The milling machine can be used to make just about any part, fixture, or jig needed in a cuemaking shop.
This is where the V-groove for the points gets cut into the front, handle, or butt sleeve.  The milling machine uses a 90* double angle cutter for milling in the point grooves.   There is a fixture on the milling table that holds the front of the cue between centers that is indexable while the point grooves are being milled.  This is also the machine where the slotted ring work is made. 

_________________________________________________

Telephone...305.677.3434
Business Hours;
Monday - Sunday
10:00am - 7:00pm
~Call for an appointment~

Ship all packages, repairs & correspondence to this address...
Please do not send joint protectors!!!
Ted Harris Custom Cues
808 South Dixie Highway
Hollywood, Florida  33020

| Welcome | About Us | Endorsements | Appearances | Cue Repair | Custom Cues | Order | What's New | Links

These pages are best viewed with Microsoft Internet Explorer 4.0 or better, in 24 bit True Color, set to 800 x 600 pixels.